gas assisted injection molding plastic parts

• Automotive ceiling handleMore+

• Gas assisted injection productMore+

• The design requirements of slider wear plate1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...More+

• Design standard of exhaust slotThe exhaust system should ensure that the gas in the cavity is smoothly discharged, and also prevent the material from entering and exhausting channels from causing flashing of the product or blockage...More+

• gas assisted injection molding moldflowMore+

• Metal Insert MoldFor rigid molded parts and curved elastic molded products on rubber gaskets, after injection molding on the substrate, an integrated product can be made, and the complicated operation of arranging the sealing ring can be omitted, making the automatic combination of the subsequent processes easier. Because it is the joining of the molten material and the metal insert, compared with the press-in molding method, the gap of the metal insert can be designed to be narrower, and the reliability of composite product molding is higher.More+

• Mold FactoryMore+

• What is 2K injection moldingMore+

• China Mold SupplierMore+

• Parting surface venting of runner systemThere are a large amount of gas in the main and sub channel, these gas are discharged through the pull rod (push rod) during injection processing, a part of gas come out from exhaust slot on parting s...More+

• Insert ProductMore+

• Slider angle designing tips1. Normally, all the insertion slopes of the slider are not allowed to be less than 3° to prevent excessive self-locking force and scratched;2. The angle of the locking surface must be bigger than th...More+