English
русский
gas assisted injection molding plastic parts
Hydraulic diameter conversion of runners in plastic mold gating system designHydraulic diameter refers to 4 times the ratio of the flow cross-sectional area to the perimeter, as the wall shear stress of non-circular pipes is not even distributed along the surrounding walls, on...More+
Overmolding & 2k MoldingMaterial selection for two-color products: The same type of material of different colors is usually used for two-color injection molding so that the bonding strength of the first color and the second color plastic is the best.More+
Multi Cavity Medical MoldMedical equipment products are divided into many different types, some products do not contact the human body, some contact the human body, some enter the body, and some products need to pass the FDA Alcohol test, some have to pass the FDA n-ethane test.More+
Insert pin of vengting design for molded partsInsert pin of venting:It is difficult to make exhaust slot when end runner is not in parting surface during injection, and there is no matching gap available, but we could make the venting pin at end ...More+
Plastic injection mold runner system designThe gate is the connecting part between the runner and the cavity, and is also the end part of the injection mold gating system, the molten plastic enters the cavity and core side through the gate dir...More+
Insert Mold PartsInsert molding is injected with plastic part processing, the insert can be plastic or metal, normally it will be metal parts or thread parts, they must be in a fixed area before injection, so it will be fitting very well after injection finishing. Normally these products request a high standard of strength.More+
