0769-8539-0209 / +86-15158220988
Sales@usm-mold.com
En
UNIQUE SOLUTIONS MOLD LIMITED
UNIQUE SOLUTIONS MOLD LIMITED
Drip Tip Mold
Products
Drip Tip Mold
Drip Tip Mold
2k Electronic Cigarette Drip Tip Mold
2k Electronic Cigarette Drip Tip Mold
2k Electronic Cigarette Drip Tip Mold Manufacturer
2k Electronic Cigarette Drip Tip Mold Manufacturer
Electronic Parts
Electronic Parts
Plastic Electronic Part
Plastic Electronic Part
Drip Tip Mold 2k Electronic Cigarette Drip Tip Mold 2k Electronic Cigarette Drip Tip Mold Manufacturer Electronic Parts Plastic Electronic Part

Drip Tip Mold

2k Electronic Cigarette Drip Tip Mold advantages: 

1. It can be produced very precise products;

2. The injection molding cycle is short, suitable for large-volume products;

3. Good product consistency and low defect rate.


BUY INJECTION MOLD
Don't Hesitate to Contact Us Now.
Related Overmolding & 2k Molding
  • The common fixing method of angle pin
    May 11 2024
    The common fixing method of angle pin
    The angle pin is a common part of the drive slider, and the fixing and installation methods as following:1. Pass through the mold plate directly and press the angle pin with the top plate to fix it, a...
  • Slider spring hength and strength calculation
    Apr 23 2024
    Slider spring hength and strength calculation
    Processing size:1. ØD2=ØD+22. Ll = total spring length (L) - preload value of spring (N) - slider core pulling distance (L2)Spring length calculation: (refer to picture 1 for length calculation)★L...
  • The design requirements of slider wear plate
    Jan 03 2024
    The design requirements of slider wear plate
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...
What's New at USM-mold
  • The common fixing method of angle pin
    May 11 2024
    The common fixing method of angle pin
    The angle pin is a common part of the drive slider, and the fixing and installation methods as following:1. Pass through the mold plate directly and press the angle pin with the top plate to fix it, a...
  • Slider spring hength and strength calculation
    Apr 23 2024
    Slider spring hength and strength calculation
    Processing size:1. ØD2=ØD+22. Ll = total spring length (L) - preload value of spring (N) - slider core pulling distance (L2)Spring length calculation: (refer to picture 1 for length calculation)★L...
  • The design requirements of slider wear plate
    Jan 03 2024
    The design requirements of slider wear plate
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...