Terms and Conditions Legal Information
Related News about Plastic Injection Molding
- December 15, 2021The 3rd China Machine Tool Purchasing Festival-DME Dongguan International Machine Tool Exhibition (hereinafter referred to as DME) was grandly closed at Guangdong Modern International Exhibition Center (Dongguan Houjie) on 13th Dec. 2021.view
- January 18, 2022In the selection of gate location, the following issues should be paid attention to:1. The gate position should be set at the maximum wall thickness of the plastic part, so that the plastic melt flows...view
- March 14, 2022In the thin-walled cavity, the end of the melt flow, the bottom of the blind hole of the mold cavity, the end of the solid column of the plastic part, the bottom of the plastic part rib and screw colu...view
- January 12, 2022The main runner is the part where the molten plastic first passes when it is sprayed from the injection nozzle, and it is coaxial with the injection nozzle, because of repeated contact and collision w...view
- January 13, 2022The sub-runner is a transitional channel between the main runner and the gate, as the sub-runner is the longgest part of gating system, so it is very important to enhance the parts quality and improve...view
- January 20, 2022In order to get the best injection quality, the gate type must be selected carefully, the coommon gate tyeps are: direct gate, side gate, pin-point gate, sub gate,valve gate of hot runner etc. Among ...view