TV bracket mold supplier

• Double Injection MoldingMore+

• The main design points of the design of the plastic mold pouring systemThe main runner is the part where the molten plastic first passes when it is sprayed from the injection nozzle, and it is coaxial with the injection nozzle, because of repeated contact and collision w...More+

• Injection MoldingMore+

• Side gate of plastic injection mold runner system designIn order to get the best injection quality, the gate type must be selected carefully, the coommon gate tyeps are: direct gate, side gate, pin-point gate, sub gate,valve gate of hot runner etc. Among...More+

• 3 Precision Molds Are Ready to Ship GermanyAfter 2 months later, the 3 molds have been finished and ready to ship. From DFM report to mold design to manufacturing and T1 samples were provided in 6 weeks.More+

• Injection Mold SupplierMore+

• BlogMore+

• Smart Home Appliance Mold ProductsMore+

• Automotive Mold SupplierWith over 15 years of experience in automotive mold development and production, USM will make mold flow analysis from the DFM report step to ensure that the pressure will be controlled at a reasonable range during injection, and there are no weld marks and other defects on the part surface.More+

• Reasons for making the exhaust system of the injection moldThe gas in the injection mold includes not only the air in the cavity, but also the air in the gate and the decomposition gas generated by the plastic melt, and the steam which caused by plastic in hi...More+

• gas assisted injection mold supplierMore+

• Design principle of plastic injection mold cooling systemDesign principle of cooling systemIn order to improve the efficiency of the cooling system and make the cavity surface temperature distribution even, the following principles should be followed in the...More+