Gas assisted injection product

• Well-ventilated steel of venting design for molded partsWell-ventilated steel is a sintered alloy, iIt is a porous material sintered with spherical particle alloys, the pore size is 7-10μm and the strength is poor, but the texture is loose which allow th...More+

• Pre-deformation MoldThe main reasons to cause the plastic parts are warpage and deformation1. The uneven wall thickness of each part of the plastic product deforms. Usually, the main part of the product is thicker and the ribs are thin, when the plastic parts are cooled.More+

• Controling method of plastic injection mold temperatureExcept for heat radiation and heat convection from the mold, most of the heat bring into the mold by the plastic needs to be taken out of the mold by the circulating heat transfer medium by heat condu...More+

• Key points of gas-assisted injection molding processGas injection parametersThe gas-assisted control part is a device that controls the gas pressure in each stage, the gas-assisted parameters have only two values: gas injection time (seconds) and gas i...More+

• Slider designing tips 2The molding parting surface of the slider molding should be made as a shut-off surface as possible, and the width of the shut-off part should be at least 8mm, and do not make a shut-off surface;When u...More+

• What is 2K molding?More+

• Plastic injection mold runner system designThe gate is the connecting part between the runner and the cavity, and is also the end part of the injection mold gating system, the molten plastic enters the cavity and core side through the gate dir...More+